Be sure to visit us in Denver, April 16–19 at the 2018 IEEE Conference and Exposition at Booth # 1866

Lean-To - Type 'LT' Buildings

Parkline Lean-To (Type 'LT') metal buildings are designed to attach to any type of existing structure. Existing Parkline buildings, any other type of metal buildings, block or brick structures, wood construction, etc. Whatever the case may be, Parkline can design a Lean-To building to fit your needs.

Lean-To type buildings have a single sloped roof with a minimum pitch of 1 1/2" over the building width. The 16" wide interlocking (self framing) roof panels shall vary from a nominal 24 to 18 gauge depending upon the loading conditions. They shall be attached to the wall cap through factory punched holes with #14 corrosion resistant fasteners.

The roof system is supported by a fluted, nominal 24 gauge, embossed, factory painted, 16" x 3" deep interlocking (self framing) wall panels. The panels are fastened at the top and bottom, to galvanized structural channels and wall caps, with 3/8" diameter electro-galvanized machine bolts thru factory punched holes.

Transmission of horizontal wind loads across the building shall be made through the roof panel system and no separate roof or wall diagonal bracing shall be required. Parkline Lean To buildings are self supporting structures and will not depend on existing structures for support.

Pre-engineered, prefabricated, steel buildings for any equipment enclosure needs. Fully assembled or site built. Perfect for electrical substation enclosures, oil and gas measurement buildings, switchgear enclosures, guard houses, pump houses, telecommunications buildings, and hazardous materials storage buildings.

Want more information about a Parkline lean-to type metal building, see the design manual (pdf) here.

Widths available: 5'4" - 20'0"
Lengths available: Unlimited